Motion detector, 50ft (15m)

Motion detector, 50ft (15m)

  • Interchangeable, pointable mirrors
  • Selectable sensitivity
  • Built-in tamper switch

The MX775i is a PIR intrusion detector that provides a variety of coverage patterns through the use of interchangeable mirrors and the choice of mirror angle settings. It is designed to be surface or corner mounted, but can be mounted with any of three optional brackets. This provides further flexibility in aiming the detector. It is designed to connect to the Multiplex Bus of a control panel and optionally to an auxiliary 12 VDC power source. It is compatible with the DS7400Xi Series Control Panels with a DS7430 or DS7436 Multiplex Expansion Module or with GV2 and G Series Control Panels with a D8125MUX Module installed.

Temperature (Operating): -29°C to +49°C (-20°F to +120°F). For UL Listed Requirements, the temperature range is 0°C to +49°C (+32°F to +120°F).
   
Standby Power: There is no internal standby battery. Connect to DC power sources capable of supplying standby power if primary power fails. For each hour of standby time needed, 350 µAh are required. For UL Listed Requirements, 4 hrs. (1400 µAh) minimum is required.
Voltage (Input): 12 VDC from panel's MUX bus and optionally from an auxiliary power supply.
Current Draw (two-wire):  
LED Off: < 350  µA draw on MUX bus
In Alarm; LED On: 2 mA draw on MUX bus
Current Draw (four-wire):  
LED Off: < 350 µA draw on MUX bus, 0 mA draw on Aux. power
In Alarm; LED On: < 350  µA draw on MUX bus, 3 mA draw on Aux. power