C900V2 Dialer intercept communicator, Ethernet

C900V2 Dialer intercept communicator, Ethernet

  • Captures alarm and event data from dialer-based control panels using CONTACT ID, SIA, Modem II, Modem IIe, Modem IIIa2, Pulse, and other formats
  • Performs full data transmissions without changing the data
  • 12 VDC to 24 VDC voltage range
  • Re-routes signals using UDP/IP-based data networks
  • Convenient connection (RJ-45 Jack) to Ethernet networks
  • Integrated 10/100 Network Interface Module, or NIM
  • Provides acknowledgement from the receiver to the control panel
  • Supports 128-bit AES Rijndael encryption

The Conettix C900V2 Dialer Capture Ethernet Module works with most control panels using a standard digital dialer format and provides end-to-end security. The module links the digital dialer to the Public Switched Telephone Network (PSTN), the digital dialer’s telephone interface, and an Ethernet network. With the Ethernet link, the C900V2 can: • Communicate with the control panel dialer • Decode and deliver signals to a Conettix D6600 Communications Receiver/Gateway • Relay a confirmation message back to the control panel dialer Whether a control panel dials through a telephone line or through the C900V2, the data remains the same. The C900V2 empowers digital dialer control panels to work over an IP network such as a Local Area Network (LAN), a Wide Area Network (WAN), or the Internet.

 
Control Panel: RJ-45 Modular Jack
Telco: RJ-45 Modular Jack
LAN/WAN: RJ-45 Modular Jack
Ethernet Cable: Unshielded twisted pair 100 m (328 ft) For 10BASE-T, use Category 3 or better. For 100BASE-T, use Category 5 or better.
   
Temperature (Operating): 0°C to +49°C (+32°F to +120°F)
   
Module Status LEDs: 2 dual-colored
   
Dimensions: 17.8 cm x 11.4 cm (7 in. x 4.5 in.)
Interface: IEEE 802.3
   
Current (Maximum): 280 mA
Voltage Range: 12 VDC to 24 VDC nominal
Alarm Outputs: Normally-open (NO) dry contacts
   
Output To LAN or WAN: UDP/IP packets