Media Converter

Media Converter

  • DIP switch configuration for "Link-Fault-Pass-Through", link down alarm, speed, duplex mode
  • 768K bits buffer memory
  • Full wire-speed forwarding rate
  • Alarms for power and port link failure by relay output
  • Redundant power inputs with Terminal Block and DC Jack

The Ethernet Fibre Optics Converter is used for electric utility automation and accept 10/100 MbpsFull/Half-duplex, Auto-Negotiation, Auto-MDI/MDIX. The Converter complies with the standard of IEC61850-3, IEEE1613 and EN50121-4.

 
Operating voltage 20 to 30 V DC (terminal block)
Power consumption 2.4W MAX. 0.2A@12VDC, 0.05A @ 48VDC
Overload current protection Present
Reverse polary protection Present
   
Material Aluminium case, IP30
Dimensions 50 x 110 x 135 mm (1.97 x 4.33 x 5.31 inches)
Weight 0.8Kg (1.76lbs.)
Installation DIN rail (top hat type 35mm), panel, rack mounting
   
Permissible operating temperature -40°C to 75°C (-40°F to 167°F)
Permissible storage temperature -40°C to 85°C (-40°F to 185°F)
Ambient relative humidity 5% to 95% (non-condensing)
 
Ethernet port 10/100BASE-TX: 1 port 100BASE-FX: 1 port
LED indicators  
Per unit Power status (Power 1, Power 2, Fault), link-fault-pass-through
Per port 10/100TX: Link Activity, full-duplex/collision, speed 100FX: Link/Activity, full-duplex/collision
Relay contact Relay contact rating with current 1A@30VDC, 0.5A@120VAC
Fibre connector type SC
   
Standards IEEE802.3 10BASE-T IEEE802.3u 100BASE-FX, IEEE802.3x
Forward and filtering rate 14,80pps for 10Mbps 148,810pps for 100Mbps
Packet buffer memory 768K bits
Processing type Store-and-forward Half-duplex back-pressure and IEEE802.3x full-duplex flow control