C900V2 Dialer intercept communicator, Ethernet

C900V2 Dialer intercept communicator, Ethernet

  • Captures alarm and event data from dialer-based control panels using CONTACT ID, SIA, Modem II, Modem IIe, Modem IIIa2, Pulse, and other formats
  • Performs full data transmissions without changing the data
  • 12 VDC to 24 VDC voltage range
  • Re-routes signals using UDP/IP-based data networks
  • Convenient connection (RJ-45 Jack) to Ethernet networks
  • Integrated 10/100 Network Interface Module, or NIM
  • Provides acknowledgement from the receiver to the control panel
  • Supports 128-bit AES Rijndael encryption

The Conettix C900V2 Dialer Capture Ethernet Module works with most control panels using a standard digital dialer format and provides end-to-end security. The module links the digital dialer to the Public Switched Telephone Network (PSTN), the digital dialer’s telephone interface, and an Ethernet network.

 
Control Panel: RJ-45 Modular Jack
Telco: RJ-45 Modular Jack
LAN/WAN: RJ-45 Modular Jack
Ethernet Cable: Unshielded twisted pair 100 m (328 ft) For 10BASE-T, use Category 3 or better. For 100BASE-T, use Category 5 or better.
   
Temperature (Operating): 0°C to +49°C (+32°F to +120°F)
   
Module Status LEDs: 2 dual-colored
   
Dimensions: 17.8 cm x 11.4 cm (7 in. x 4.5 in.)
Interface: IEEE 802.3
   
Current (Maximum): 280 mA
Voltage Range: 12 VDC to 24 VDC nominal
Alarm Outputs: Normally-open (NO) dry contacts
   
Output To LAN or WAN: UDP/IP packets