The LECTUS duo 3000 classic line consists of two readers for MIFARE classic cards and transponders. They support the data record of Bosch coded MIFARE credentials and the CSN of ISO14443A cards as well. Both readers provide a 26 Bit Wiegand and RS485/ OSDP host interface, selectable easily by DIP switch. When operating in RS485/OSDP mode up to eight readers can be connected to a respective controller, e.g. AMC2-4R4. Reader address is settable via four DIP switches individually. Running in that mode readers can be easily supervised.
| Electrical characteristics |
|
| Input voltage |
8.5 V to 16 Vdc - max. 18 Vdc |
| Current draw |
65 mA @ 12 VdcMax.: 130 mA @ 12 Vdc |
| Operational Characteristics |
|
| Tamper output |
Open collector, active low, 32 mA max sink current. Optical Technology |
| Wiegand D0 output |
5 V (TTL) |
| Wiegand D1 output |
5 V (TTL) |
| Green LED control input |
Active low |
| Red LED control input |
Active low |
| Buzzer control input |
Active low |
| RS485 |
OSDP protocol |
| Wiegand IF |
D0/D1 Wiegand protocol |
| Keypad |
LECTUS duo 3000 C: none LECTUS duo 3000 CK: 2x6 |
| Environmental Characteristics |
|
| Operating environment |
Indoor and outdoor use - all weather. |
| Operating temperature |
-25 °C to 65 °C (-13 °F to 150 °F) |
| Operating humidity |
0 to 95% (Non-condensing) |
| IP rating |
IP65 |
| UV-light resistant |
Yes |
| Vandal resistance |
IK08 |
| MIFARE & Cards Specification |
|
| Read range - ISO cards |
> 6 cm (2.36 in.) |
| Key fob |
> 2 cm (0.78 in.) |
| Supported cards |
MIFARE 13.56 MHzISO 14443 Type A |
| Anti-collision support |
Yes |
| NXP chips supported |
MF1ICS20 - 320 byte MF1ICS50 - 1K MF1ICS70 - 4K |
| MIFARE MAD, CSN Support |
|
| The reader follows the MAD rules |
|
| Reads INIT CSN |
Yes |
| Reads CSN after non-detection of MAD information |
Yes |
| Physical Characteristics |
|
| Dimensions (L x W x D) |
137 mm x 44 mm x 27.5 mm (approx. 5.39 in. x 1.73 in. x 1.08 in.) |
| Weight |
Approx. 220 g (0.5 lb) |
